Advertisement
INSTALLING THE REMOTE HEAD
One or two remote heads can be connected to the main base unit. The connections at the rear of the unit are identical in func-
tion. CA cables of the same style and pin-outs as the audio CA cables will work to mount the remotes. See page 6.
1. When mounting the remote head flush to a flat surface, use the unit as a template to mark and drill (4) mounting
holes 7/64" diameter for sheet metal screws or 5/ 32" for machine screws.
2. The cable can exit the unit in (4) directions: Flush to the outside of the mounting plane in the up, down and right
side direction or through the mounting plane on the back. When exiting up, down and right, a small wire groove
is provided.
3. Cut a small piece of plastic from the desired groove to clear the wire as shown in Figure 3.
FIGURE 3
4. For an installation where the wire passes through the mounting surface, drill a 3/8" hole and install the supplied
rubber grommet. Pass the wire through.
5. Click the CA cable into the remote head modular jacks, as shown in Figure 4.
6. For inside installation, mount the panel with (4) screws making sure the cable is not pinched in the groove.
4
I N S T A L L A T I O N
FIGURE 4
Advertisement
