Advertisement
7. When mounting the remote head using the brackets, first plug in and thread the cable through the bracket assembly
as shown in Figure. 5.
8. Plug the CA cable into the remote head and secure the panel with (4) machine screws and nuts to the front of
the bracket.
9. Using the supplied cable ties, secure the CA cable to the bracket anchors as shown in Figure 6.
10. Before installing the bracket to the mounting surface, drill a 3 /4" hole at the wire location. Snap the grommet into the
bracket as shown in Figure 6 and then use the bracket as a template to mark the mounting holes.
11. Drill (4) mounting holes at 7/64" for #6 sheet metal screws or 9/64" for #6 machine screws.
12. Mount the bracket and adjust the panel to a desirable viewing angle with the two hand knobs.
I N S T A L L A T I O N
FIGURE 5
FIGURE 6
5
Advertisement
