10.0 operation
EN
10.1 on/off switch
!
WARNING
•
This should be performed after both the appliance and DHC™ Plus have been fully installed, including all
venting and finishing materials.
For optimal performance, the on/off switch in the blower housing must ALWAYS be set to the maximum speed
setting.
note:
If a lower speed is selected (at the blower housing or remote) to reduce air flow, the result may be a minor
imbalance of the motor that causes a minor humming. While this will not affect the longevity of the motor, it may
result in a noticeable noise depending on the location of the DHC™ Plus blower kit.
10.2 using remote control
The remote control has 5 different blower speed settings. For optimal performance, the remote control must
ALWAYS be set to the maximum speed setting.
note:
If a lower speed is selected (at the blower housing or remote) to reduce air flow, the result may be a minor
imbalance of the motor that causes a minor humming. While this will not affect the longevity of the motor, it may
result in a noticeable noise depending on the location of the DHC™ Plus blower kit.
30
W415-1789 / C / 01.29.19