Tunturi FitRun 50i User Manual page 20

English
NOTE
• Some circuit breakers used in homes are not
rated for high inrush currents that can occur
when a treadmill is first turned on or even during
normal use. If your treadmill is tripping the circuit
breaker (even though it is the proper current
rating and the treadmill is the only appliance
on the circuit) but the circuit breaker on the
treadmill itself does not trip, you will need to
replace the breaker with a high inrush type. This
is not a warranty defect. This is a condition we as
a manufacture have no ability to control.
Unfolding and folding the
equipment (fig. F1-F2)
The equipment can be unfolded for use (fig. F1) and
folded for transport and storage (fig. F2).
Refer to the illustrations for the correct way of unfolding
and folding the equipment.
CAUTION
• Before folding the equipment, make sure that
the incline is 0%. If the incline is not 0%, folding
will damage the mechanism.
Console (fig. E-1)
CAUTION
• Keep the console away from direct sunlight.
• Dry the surface of the console when it is covered
with drops of sweat.
• Do not lean on the console.
• Only touch the display with the tip of your finger.
Make sure that your nails or sharp objects do not
touch the display.
NOTE
• The console switches to standby mode when the
equipment is not used for 4 minutes.
Buttons
STOP
- Press once, stop workout/ treadmill gently.
- Press twice, stop workout/ treadmill more rapidly.
- Press and hold for two seconds in idle mode to
reset console settings/ clear ERR message.
SPEED Up
- Increases the speed (1.0 - 16 Kph).
- Pressing once increases the speed 0,1 kph.
- Pressing and holding for two seconds will increase
the speed faster.
- Scroll programs and change values in programming
mode.
SPEED Down
- Decreases the speed (1.0 - 16 Kph).
- Pressing once decreases the speed 0,1 kph.
- Pressing and holding for two seconds will decrease
the speed faster.
- Scroll programs and change values in programming
mode.
INCLINE up
- Increases the incline (0%~10% ±1%).
INCLINE down
- Decreases the incline (0%~10% ± 1%).
MODE
- Press to select program target mode when treadmill
is in programming mode:
Cycle the FAT parameters when being in FAT
programming mode.
PROGRAM
- Press to Cycle through the possible programmes.
( P0/ P1~P36/ U01~U03/ FAT )
START/ PAUSE
- Start selected workout, or restart pause workout
when being in pause mode.
- Pause active workout.
Speed hot keys:
Speed Hot Keys are set as 3, 6, 12, 16.
For example, the speed changes from any speed to 8
km/h by pressing the Speed Hot Key 8.
Incline hot keys.
Incline Hot Keys are set as 6, 9 &12%.
For example, the incline level changes from any level to
6% by pressing the Incline Hot Key 6.
Handle bar speed quick-access keys:
- + Same as Speed +.
- – Same as Speed –.
Handle bar incline quick-access keys:
- + : Same as Incline +.
- - : Same as Incline –.
Explanation of display items (Fig. H)
Speed
- Shows the actual treadmill speed in workout mode.
- Shows target speed in programming mode.
- Shows program selection when being in program
mode.
2 0