The Heater Controls; The Graphical User Interface (Gui) - andrews CWH 30/201 Operating Instructions Manual

1.0 INTRODUCTION
1.1 HEATER CONTROLS
1
2
1 Operation switch
3 Control knob (push to enter)
1.2 THE GRAPHICAL USER INTERFACE
The control knob is used to operate the GUI. The display is organised into a navigation bar, status bar, and
work area.
Home page
Hot water page
Information page
Setup page
The water heater is operated by rotating the control knob to move the selector over the screen then push-
ing the control knob to select the item. When selected the item will be displayed as inverse and can then be
changed by rotating the control knob and the change is confi rmed by pushing the control knob.
If the item was selected by mistake, take your hand off the control knob (do not push the control
knob) ,wait for 5 seconds and the item will de-select and revert to its previous value.
In order to return to the previous screen select the back "arrow" or "back" text in the bottom right corner of the
screen at any time
Introduction
Cascade fl ow temp 60.3 O C
DHW temp 1 58.2 C
O
2 Reset switch
4 Graphical User Interface
Cascade fl ow temp
DHW temp 1
7
60.1 o C
58.9 C
o
3
4
Work area
MAXXfl o EVO