Symbol Spectrum24 AP-4131 Product Reference Manual page 73

AP-4131 Access Point Product Reference Guide
Access Allows the user to set one of three Access Control
Control modes: Disabled, Allowed, or Disallowed.
•
•
•
Type Filtering Specifies filter type for packets received either
Forward/Discard or Disabled.
The default value is
WNMP Specifies if the AP can perform WNMP functions.
Functions The default value is
AP-AP State Specifies AP-to-AP communication exchanged.
Xchg
Max Specifies the maximum number of MUs (127) that
Associated are allowed to associate with the access point.
MUs
MU-MU If enabled, mobile units associated with the same
Disallowed AP are not allowed to communicate with each
other.
Modem The default setting is
Connected dial-up configuration.
Inactivity The inactivity time on the UI that causes the AP to
Timeout terminate the connection while using a modem.
The default is
range.
The
When (default) is selected, no filtering
is performed.
When is selected, only MAC addresses
specified in the Access Control List are allowed
to associate with the AP .
When is selected, only MAC
addresses not specified in the Disallowed
Addresses List (Address Filtering) are allowed
to associate with the AP .
minutes from a
value indicates no time-out.
Configuring the AP
.
.
. Set to when using a
to -minute
63