Opening The - Siemens NCU 7 0.2 Series Manual

Connecting
7.3 Opening the front cover
7.3 Opening the front cover
Introduction
The interfaces are concealed behind a front cover. You must remove this cover before you
can wire the interfaces.
A hinge connects the front cover to the front of the housing. Once opened, the cover can be
completely removed. When the front cover is closed (flipped up), it automatically locks into
place by means of a hook on the connector panel.
Procedure
1. Disengage the release hook on the inside of the front cover (the front cover is open and
2. Remove the front cover with a forward motion.
Figure 7-2
Note
All cables must be routed vertically upwards to the fullest extent possible so that the front
cover can be closed. The front cover is open and in the up position.
48
in the up position).
Removing the front cover
Manual, 02/2011, 6FC5397-0AP20-0BA0
NCU 7x0.2