Table of Contents
Advertisement
CAUTION!
Never immerse the motor block in water or other liquids, do not wash it in the
running water or dishwasher.
o Wipe the motor block and the supply cable with soft, moistened cloth. Protect the
device from the water penetration. Dry the device thoroughly with soft, dry cloth.
o Always use the soft cloth only, never use any abrasive cleaning agents which may
damage the device surfaces.
o In case of longer inactivity period clean the device according to the description above
and store in dry and clean place, protected from frost, sunlight, and out of reach of
children.
o Do not place any heavy objects on the device.
7. Possible Malfunctions
In case of anomalies use the table below before calling the service company or informing
the vendor.
Problem
The device is
connected to the
power supply but the
ON/OFF button lamp
is not working
The ON/OFF button
lamp illuminates, the
speed level is
selected but the
device is not working.
When the anomalies cannot be removed:
disconnect the device from the socket (pull the plug!)
-
do not open the housing
-
contact the vendor.
-
Cause
• Plug improperly inserted into
socket.
• The ON/OFF button is not
pressed.
• The overload / overheating
protection was triggered.
• The device worked for
too long and turned off
automatically.
Solution
• Remove the plug and
insert it properly into the
socket.
• Press the ON/OFF button
• Press RESET button
located in the device
bottom. (See fig. in
page 27)
• Remove the plug and
leave the device for
cooling down before
reactivation. If the
protection is triggered
again contact the vendor.
- 31 -
Advertisement
Table of Contents
