HermanMiller Verus Adjustment Manual

HermanMiller
Verus Chair
™
Seat Height: Paddle-shaped lever on right side
At the proper height, your feet should rest flat on the floor.
Tilt Tension: Long stem on right side with knob
Available on most models.
There are six positions on the tilt tension knob.
Set the tilt tension to control the resistance you feel when leaning back.
For the Semi Synchronous tilt with Tilt Limiter, the tension is pre-loaded to
adjust to the user.
HermanMiller Verus Chair
™
To raise:
While taking your weight off chair,
lift lever up.
To lower:
While seated, lift lever up.
To increase tension:
While seated, turn knob forward
(toward + sign).
To decrease tension:
While seated, turn knob backward
(toward – sign).
Seat Depth: Lever under right side of seat
Only available on some models.
In the proper position, you will have approximately three-fingers of clearance
between the back of your knees and the seat edge.
Tilt Limiter: Knob below left side of seat
There are five positions on the tilt limiter knob.
Engage the tilt limiter when you want to sit in an upright or partially
reclined position.
1
To increase depth:
Pull lever out, slide thighs forward to
adjust seat; release lever.
To decrease depth:
Pull lever out, push seat back and
release lever.
To limit tilt range:
Turn counterclockwise to limit the level
of recline
To release tilt limiter:
Turn clockwise to increase the level
of recline
Adjustment Guide