HermanMiller Aeron Disassembly For Recycling

Y
Tools Required:
Power Driver 2 lbs Hammer
Materials Identification and Segregation:
Where possible, plastic components are marked with ASTM recycling codes. Use
these codes to identify material type for recycling. Non marked components should
be treated as mixed plastic. Ferrous metals can be identified using a small magnet
for recycling. Non-ferrous metals should be separated and recycled separately.
Disassembly Steps:
1. Lay chair on back.
Z
© 2014 Herman Miller, Inc. Zeeland, Michigan. Printed in the U.S.A.
® Y, Z, and Aeron are among the registered trademarks of Herman Miller, Inc.
Illustrations and specifications are based on the latest product information available at the time of publication.
The right is reserved to make changes in design and specifications at any time, without notice, and also to discontinue products.
Safety Glasses
Torx Bit
Aeron Disassembly for Recycling
®
Rubber Mallet
2. Grasp and pull to remove
casters from the base.
Part no. 1b9vtf rev A.
1