Operation; Switching On And Off; Setting The Cutting Depth (Dive Depth); Setting The Cutting Angle (Mitre Angle) - Parkside PTSS 1200 C1 Instruction Manual

Switching on and off

Switching on:
♦ Push the safety lock-out
in position .
♦ Press the ON/OFF switch
running, you can release the safety lock-out
Switching off:
♦ Release the ON/OFF switch

Setting the cutting depth (dive depth)

♦ Undo the screw for the cutting depth adjust-
ment and push the stop to the desired
cutting depth on the cutting depth scale
–
without guide rail, see mark A .
–
with guide rail, see mark B .
♦ Retighten the screw for the cutting depth adjust-
ment .
NOTE
► Adjust the cutting depth to the thickness of the
workpiece . Less than a full tooth height
should be visible below the workpiece .
Setting the cutting angle
(mitre angle)
♦ Loosen the two adjustment wheels for the
cutting angle .
♦ Tilt the motor to the desired cutting angle .
♦ Retighten the adjustment wheels
NOTE
► If you have set the cutting angle adjustment to
0° or 45°, you can use the fine adjustment
screws and
8a
ment that you require .
■ 8 │ GB │ IE │ NI
upwards and hold it
. Once the saw is
.
.
to make any fine adjust-

Note the cut line

♦ Cut line markings
into the base plate
♦ Align the appliance to the corresponding 0°
or 45° cut line markings
. with the set cutting angle .
♦ The inclined surfaces are reference points for
this .
:

Connecting the guide rails

The guide rails
cuts .
♦ To connect the 2 guide rails, push the connec-
tor into the groove of the guide rails . Tighten
the grub screws
NOTE
► The guide rails
(black rubber lip) . The splinter guard must be
adjusted before making the first cut . Place the
guide rail onto a workpiece . Set a cutting
depth of approx . 10 mm . Switch the circular
saw on and push it gently and evenly in the
cutting direction .
of 0°/45° are imprinted
9a
.
in accordance
9a
will help you to make straight
using the Hex key supplied .
have a splinter guard
PTSS 1200 C1
9a