■
Do not allow the teeth of the saw blade to
overheat .
■
When sawing plastic, avoid melting the plastic .
■
Wear a dust mask when sawing .
■
Only use recommended saw blades .
■
Always wear hearing protection!
Safety information for circular saw
blades
Wear protective gloves!
Wear a dust mask!
Wear protective goggles!
Wear hearing protection!
Original accessories/auxiliary
equipment
■
Only use the accessories and additional
equipment that are specified in the oper-
ating instructions and compatible with the
appliance.
Operation
Fitting/changing the saw blade
Always remove the plug from the power socket
before working on the appliance .
NOTE
►
Position the base plate for this operation on
the edge of a stable surface so that the saw
blade
can be lowered .
1 . Activate the safety lock-out
motor unit
forwards .
2 . Open the clamping lever
lock-out
. The motor unit clicks into place . The
movement of the motor unit is blocked upward
and downward .
3 . The clamping screw/washer
tion
.
14
b
PTSS 1200 C1
and push the
. Release the safety
is now in posi-
14a
4 . Press the spindle lock button
Hex key
to open the clamping screw/
washer
.
14a
5 . Remove saw blade
NOTE
Ensure that the factory-fitted flange X stays in
►
place during installation and removal (see fig . A) .
Fig . A
6 . Fitting a saw blade
reverse order .
WARNING!
►
The direction of rotation of the saw blade
and the machine must match .
Connecting the sawdust extraction
device
♦
If required, attach the adapter for dust extrac-
tion
to the chip ejector
♦
Connect an approved dust and chip extraction
device .
Check that the blade guard is
functioning
NOTE
►
Position the base plate for this operation on
the edge of a stable surface so that the saw
blade
can be lowered .
♦
Activate the safety lock-out
circular saw .
♦
Check whether the saw blade
the blade guard and whether it moves back to
its starting position automatically .
Operation
and use the
.
X
is carried out in the
.
and lower the
rubs against
GB │ IE │ NI
│
7
■