Yale SL7000 Series Installation Instructions

Digital Lock Set
Installation Instructions
7) Mounting the Lock
Select the fixing screws to suit the door thickness.
* Fit the neoprene seals to both the Exterior Code Pad
and Interior Handle Assemblies.
* Hold the Exterior Code Pad Assembly onto the door with
the spindle bar and spring in position and ensuring that the
square bar engages the hub in the mortice lock assembly.
* Locate the Interior Handle Assembly on the inside of the
door engaging the square spindle in the handle hub.
* Screw both side together using the fitting screws top and bottom. (FIG 1)
* Before tightening of fixing screws make sure the lock is vertical
* Test the mechanism to ensure that the lock functions
correctly and moves easily.
DO NOT overtighten the fixing screws-this may cause
distortion and lead to poor operation.
NOTE: CHECK THAT THE CODE WORKS TO AVOID
FIG 1
A LOCKOUT BEFORE CLOSING THE DOOR.
Digital Lock Set-Passage Mode Function
* Enter correct code, turn the handle of Digital Exterior Code
Interior Code Pad
Pad Assembly to 4 o'clock position and hold the handle in
Assembly
downward position .
* Turn the passage knob of Digital Interior Code Pad Assembly
from 12 o'clock to 9 o'clock "P" position. Release the handle
passage
knob
* To cancel pull down outside handle and turn the passage knob
back to the 12 o'clock position.
Digital Lock Set-Changing the Code Number
1) The digital lock is supplied with factory setcodes: C13579
2) Depress the code select button and slide the selector
from "NON CODE" to "CODE" position and the active
number is selected as shown by the RED indicator.
3) Any numbers not required to be part of the active code
should have the code selectors parked in the
"NON CODE" position.
4) The "CLEAR" button MUST always be used as the
first digit of a code.
5) For best security the code number selected should
contain 4 or 5 digits.
code
6) Check that the new code works before installation.
select
NOTE: THE CODE IS NON-SEQUENTIAL
buttons
MAY BE ENTERED IN ANY ORDER
and "Passage Mode is now set to give free access without
the need to enter the code.
Digital Lock Set
SL7000 Series
Components
2
3
4
4
8
9
1. Digital Exterior Code Pad Assembly
2. Neoprene Seals x 2
3. Digital Interior Code Pad Assembly
4. Fixing Screws x 2 - 60mm
(2 Spare 70mm & 2 Spare 80mm).
5. 8mm Square Spindle (Drive Bar) x 78mm
6. Spindle Spring
1
2
5
6
11
7
7. Mortice Lock - 60mm Backset with
Strike Plate, Fixing Screws x 5,
Cylinder Retaining Screw x 1
8. Euro Profile Cylinder with 2 Keys
9. Cylinder Escutcheons
10. Instructions & Template
11. Allen key