Attach Seat - AmeriGlide HORIZON PLUS Installation Manual

ATTACH SEAT

1. Remove seat from packing and
place on drive unit. Run cables
through the hole in the seat. Line
up screw holes between seat and
leg chassis.
2. Fit Seat using 4 x 8mm hex bolts
and tighten.
3. Connect seat cables.
Lift manual swivel levers and turn chair, make sure it
locks securely at either end of travel and that the swivel
interlock switch operates correctly.
4. Secure wiring looms with tie-wrap supplied taking
care to ensure that cables & plugs cannot be damaged
when "swiveling".
5. Place chair wiring cover in place and secure down
with furnished plastic push pins.
5
6
6. Slide cover on from bottom
of rail.
1
7
7. Connect the remaining wires
to the two connecters on the
seat cover.
2
3
4
DO NOT attach the
cover yet. It needs to
be off in order to check
the software in the next
step.
19