Grass Collector; Mulch Plug; Adjusting The Cutting Height - FLORABEST FARM 40-Li A1 Operation And Safety Notes Translation Of The Original Instructions

Attaching carrying handle on grass
collector
1. Attach front end of the carrying handle
to the slot of the grass collector
2. The hook at the front end of carrying
handle should snap fit into the cover of
11a
the grass collector
the carrying handle

grass collector

11
3. Apply small pressure to the carrying
handle until the hook at the rear end of
11a
the carrying handle snap fit into the cover of
the grass collector
NOTE
Fabric handle is available at the back of
u
grass collector
11
Attaching the grass collector
1. Lift the discharge cover
and hold it in position (see Fig. I).
2. Hold the grass collector
hand by its carrying handle
hang it with its supports into the hooks on the
housing .
9
3. Release the discharge cover
Removing the grass collector
1. Lift the discharge cover
and hold it in position (see Fig. I).
2. Hold the grass collector
hand by its carrying handle
from the hooks on the housing
3. Release the discharge cover
Emptying the grass collector
Observe the fill indicator flap
grass collector during operation. The flap
11
should open up by the air flow through the grass
collector with available capacity. A closed flap
11
indicates a full grass collector
emptied before continuing operation.
1. Remove the grass collector
"Removing the grass collector").
2. Dispose of the cut grass through the open
side of the grass collector
local regulations.
16 GB
11a
(see Fig. H).
11
. Attach the rear end to
11
to the end slot of the
11a
.
.
11
.
with one hand
4
with the other
11
and
11a
.
4
with one hand
4
with the other
11
11a and lift it
.
9
.
4
on top of the
11b
and it must be
11
(see
11
according to
11

Mulch plug

Q
This product can be used for mulching grass with
the mulch plug . The mulch plug will block the
19
rear discharge opening. The cut grass is chopped
several times to produce tiny bits of grass. The
cuttings will be left on the lawn where they will
soon rot down and perform fertilizing function.
Attaching the mulch plug
1. Lift the discharge cover
and attach the mulch plug
Removing the mulch plug
1. Lift the discharge cover
and remove the mulch plug

Adjusting the cutting height

Q
This product has 6 settings to adjust to one of the
below cutting heights.
Setting
1. Disengage the height adjustment lever
by pushing it sideways out of the notch for the
current setting (see Fig. J).
2. Move the height adjustment lever
forth towards the notch for the desired cutting
height.
3. Engage the height adjustment lever
pushing it sideways into the notch of the
desired cutting height.
with one hand
4
.
19
with one hand
4
.
19
Cutting height
(ca.) in mm
75
65
55
45
35
25
6
back or
6
by
6