Accessories; Assembly; Before Use; Charging The Battery Pack - FLORABEST FARM 40-Li A1 Operation And Safety Notes Translation Of The Original Instructions

4. Ensure that you have all the accessories and
tools needed for assembly and operation.
This also includes suitable personal protective
equipment.

Accessories

Q
To operate this product safely and correctly, the
following accessories, i. e. tools and attachments,
are necessary:
Suitable personal protective equipment
o
Accessories and tools are available through your
authorised dealer. When buying always consider
the technical requirements of this product (see
"Technical data").
If you are not certain, ask a qualified specialist and
get advice from your trusted dealer.
NOTE
This instruction manual contains information
u
and suggestions for several attachments and
their uses. The attachments mentioned are not
necessarily included in the shipment, but are
meant to indicate additional possibilities for
using this product.

Assembly

Q
Attaching the lower bar
1. Fold up the lower bar
height and engage the gears in a secure
position (see. Fig. D). Raise both lower
bars to the same height.
3
2. Turn the lever
10b
connection, but to not fully tighten it.
3. Tilt down the lever
connection. If this requires too much force or
is impossible loosen the lever
turning it anti-clockwise.
4. Repeat step 1 – 3 on the other side.
Attaching the upper bar
1. Align the open end of the upper bar
the lower bars
3
holes in both parts are congruent with each
other and hold it in place (see Fig. E).
2. Fit the bolt from the product centre
13a
outward through the holes and hold it in
place.
14 GB
to a convenient
3
clockwise to tighten the
to secure the
10b
a little by
10b
with
2
and slide it down until the
3. Slide the washer
13b
outwards onto the bolt
washer should fit the upper bar
13b
4. Screw the lever
13c
5. Turn the lever clockwise to tighten the
13c
connection, but to not fully tighten it.
6. Tilt down the lever
connection. If this requires too much force or
is impossible loosen the lever
turning it anti-clockwise.
7. Repeat step 1 – 6 on the other side.
Securing the control cable
1. Use the cable clip
cable through the open end (see Fig. F).
14
2. Clip the cable clip
cable onto the lower bar
14

Before use

Q

Charging the battery pack

Q
NOTE
The battery pack
17
u
Charge the battery pack
ideally at least 60 minutes.
Always pull out the power plug
u
charger from the mains before removing
18
or connecting the battery pack
charger.
Never charge the battery pack
u
the ambient temperature is below 10 °C or
above 40 °C.
Rest the charger
18
u
between successive charging sessions.
If no battery pack
u
charger and the charger is connected to
18
mains, the charging status LED
green.
1. Align the battery pack
charger and slide it in. Ensure it clicks
18
noticeably in place.
with the flat side facing
. The recess of the
13a
.
2
onto the bolt .
13a
to secure the
13c
a little by
13c
and insert the control
12
with the control
12
.
3
comes partly charged.
prior to first use,
17
of the
18a
to the
17
when
17
for at least 15 minutes
is inserted into the
17
flashes
18d
to the rails of the
17