Checking The Battery Charging Level; Safety Key; Attaching / Removing The Battery Pack; Operation - FLORABEST FARM 40-Li A1 Operation And Safety Notes Translation Of The Original Instructions

2. Connect the power plug
charger with the mains. The charging
18
status LED lights up red. The continuously
18c
lit green charging status
LED indicates that the charging process is
18d
complete.
3. Disconnect the power plug
charger
from the mains and remove the
18
battery pack from the charger.
17
4. Attach the battery pack
product (see "Attaching / removing the
battery pack").
Charging status LEDs
Green LED flashes
without battery pack
Green LED lights up
with battery pack
Red LED lights up with
battery pack
Red and green LEDs
flashing
Red and green LEDs
continuously lit
Checking the battery charging
Q
level
Press the battery level button
o
charging level of the battery pack
charging level will be shown on the battery
level indication lights
4 Green LEDs
continuously lit
3 Green LEDs
continuously lit
2 Green LEDs
continuously lit
1 Green LED
continuously lit
1 Green LED flashing Low battery charging level
Charge the battery pack
o
when it is at 25% or low battery charging
level.
of the
18a
of the
18a
back to the
17
Charger ready
Battery pack fully
charged
Battery pack charging
Battery pack defect
Battery pack too cold
or warm
to check the
17c
. The
17
.
17b
100% battery charging
level
75% battery charging level
50% battery charging level
25% battery charging level
before operation
17

Safety key

Q
This product is equipped with a safety key
prevent unauthorised use. In order to operate the
product the safety key
safety keyhole .
7b
Engaging the safety key
1. Open the battery compartment cover
(see Fig. G).
2. Press the button on the safety key
slide it into the safety keyhole
it clicks noticeably in place. It shall not be
possible to remove the safety key
without pressing its button.
Disengaging the safety key
1. Press the button on the safety key
pull it out of the safety keyhole
Attaching / removing the
Q
battery pack
Attaching the battery pack:
1. Open the battery compartment cover
(see Fig. G).
2. Align the battery pack
battery pack bay and slide it into it. Ensure it
clicks noticeably in place.
Removing the battery pack:
1. Open the battery compartment cover
(see Fig. G).
2. Press the release button
battery pack from the battery pack bay.
17

Operation

Q
Grass collector
Q
This product can be used with a grass collector
that holds the cut grass for easy disposal. If not
used, the cut grass will be ejected through the rear
discharge opening.
To clear the rear discharge opening the mulch
plug must be removed.
19
1. Lift the discharge cover
and remove the mulch plug
7c
must be engaged in the
7c
7
and
7c
. Ensure
7b
7c
and
7c
.
7b
7
to the rails of the
17
7
17a
and slide out the
with one hand
4
.
19
GB
to
11
15