Mounting The Grass Box; Operation; Hanging On/Removing The Grass Box; Level Gauge - FLORABEST FRMA 36 / 2 B1 Translation Of The Original Instructions

Mounting the grass box

Wear gloves when mounting the
grass box (4), to avoid risk of in-
jury.
See also the enclosed information
for installation of the grass box.
1. Assemble the two parts of the
lower section (4a) of the grass
box.
2. Place the upper section (4b) of
the grass box on the lower sec-
tion (4a). It then locks into place
in the recesses provided for this
purpose in the upper section.

Operation

The apparatus must only be
adjusted when the motor is
switched off and the blades
are stationary. There is a risk
of personal injury.
Switch off the apparatus, remove
the ignition key (
for the blades to come to a stand-
still.
Hanging on/removing the
grass box
1. To hang on the grass box (4), lift
the collision guard (5) and hang
on the grass box using both sup-
ports.
2. Fold the collision guard (5) onto
the grass box (4). It holds the
grass box in the correct position.
10) and wait
3. To remove the grass box (4),
lift the collision guard (5) and
detach the grass box. Fold the
collision guard (5) back onto the
mower housing (8).
Do not operate the appliance
without the collision guard or
the grass box. Risk of injury!

Level gauge

The level gauge (
side of the grass box (
Level gauge flap open:
Grass box empty.
Level gauge flap closed:
Grass box full.

Adjusting the cut height

The apparatus has 6 positions for adjusting
the cutting height:
35 mm/25 mm - Short cutting height
55 mm/45 mm - Medium cutting height
75 mm/65 mm - Tall cutting height
1. Hold the carrying handle (14)
and lift the device or press the
device down.
2. Grip the lever (13) for adjusting
the cutting height and move it
past the ratchet mechanism to
the desired cutting height.
The correct height is around 25 – 45 mm
for a decorative lawn and around 45 –
65 mm for a used lawn.
A higher cut height should be se-
lected for the first cut of the season.
GB
4c) is located on the
4).
1 5