5.1
Connecting DMX signal
The connection is performed using cable with XLR-female -> XLR-Male plugs.
120Ω
3
2
1
DMX Controller
5.2
Voltage specification
Input Voltage
110~240V
5.3
Connecting power supply
The connection is performed using power cable with PowerCon connector (included).
The device must be operated by qualified personnel. Make sure that the power grid supply parameters are
consistent with device parameters and limitations are not exceeded.
CAUTION!
In the case of cable damage do not attempt to repair. Replacement or repair can be made only
on the manufacturer or by a person with appropriate permissions.
6
OPERATION MANUAL
6.1
Control panel
The control panel is equipped with LCD display and control wheel.
www.flash-butrym.pl
PIN 3
FEMALE
PIN 2
DMX 512
Total Power
400W
GROUND
1
3
2
XLR
DMX 512
DMX +
DMX -
Frequency
50/60Hz
1
3
2
MALE
XLR
4