Related Manuals for Pyle Pro PDWM4520
Summary of Contents for Pyle Pro PDWM4520
- Page 1 PDWM4520 PDWM4540 PDWM4560 PDWM4520 - PDWM4540 - PDWM4560 Wireless Microphone System...
- Page 2 CATALOG FOREWORD This professional wireless set provides a high quality microphone with UHF radio system for freedom of movement without loss of audio quality. Please read this manual before using this equipment in order to avoid damage 1. FOREWORD - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - through incorrect operation and to get the best performance from your 2.
-
Page 3: Four Channel Receiver Features
FOUR CHANNEL RECEIVER FEATURES MICROPHONE-TRANSMITTER FEATURES 1. Power Button: Power ON/OFF the receiver. 2. Power Indicator: Indicates the power ON/OFF. 3. "AF"Audio Level lndicator: Indicates the wireless system audio signal level. 4. Volume Knob: Adjust the volume output of receiver. 1. -
Page 4: Transmitter Battery Installation
BODY-PACK TRANSMITTER FEATURES TRANSMITTER BATTERY INSTALLATION 1. Battery Installation of Handheld Microphone: Open the battery cover. Insert the supplied batteries into battery jar in polarity and cover the battery cover. 2. Battery Installation of Bodypack Transmitter: Push open the battery cover. -
Page 5: Bodypack Transmitter Connection
BODYPACK TRANSMITTER CONNECTION SYSTEM CONNECTION 1. Receiver Power Connection: Connect the DC connector of supplied AC/DC 1. Lavalier Microphone Connection: Connect the connector of supplied adapter Into the DC power input of receiver. Plug the AC Input connecter lavalier microphone to the connecting jack of transmitter (shown as below) into an AC120/60Hz or AC220V/50Hz outlet. -
Page 6: Troubleshooting
TROUBLESHOOTING The audio gain control on transmitter has been factory-at the mid-range position for best performance in most applications. This may be necessary PROBLEM INDICATOR STATUS SOLUTION Red transmitter Slide transmitter POWER ON/OFF switch for soft singers or talkers, or guitar or basses with low outputs. No Sound indicator is not to ON position. - Page 7 SYSTEM SPECIFICATIONS HAND-HELD TRANSMITTER SPECIFICATIONS • Wireless Operating Frequency Range: Power Requirements 1.5VAA battery X 2 Approximately 573.0 - 597.8 MHz (Available frequencies depend on Nominal Current Drain LESS THAN 100mA applicable regulations in country where system is used). Modulation Type •...
- Page 8 Pyle PDWM4520 Wireless Microphone System, UHF Quad Channel Fixed Pyle PDWM4540 Wireless Microphone System, UHF Quad Channel Frequency, 4 Handheld Microphones, Rack Mountable Fixed Frequency, 2 Handheld Microphones, 2 Body-Pack Transmitters, 2 Headset & 2 Lavalier Mics, Rack Mountable UHF Band Receiver System •...
- Page 9 • Battery Powered: 2 x 'AA' Batteries (Included) System Receiver: • Batteries Included • Image & Spurious Rejection: >70dB • Weight: 180g • Receiving Sensitivity: -105dBm • Signal/Noise Ratio: >105dB Transmitters: • Border Upon Channel Rejection: >70dB • RF Power Output: >10dBm •...
Need help?
Do you have a question about the PDWM4520 and is the answer not in the manual?
Questions and answers