Installing the palm-rest and keyboard assembly
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
Place the palm-rest and keyboard assembly on a flat surface.
Next steps
1. Install the
system
board.
NOTE:
The system board is removed and installed with the heat sink attached, when replacing the palm-rest and
keyboard assembly. This simplifies the procedure and avoids breaking the thermal bond between system board and
the heat sink.
2. Install the
power-button board
3. Install the
power-adapter
4. Install the speakers.
5. Install the
coin-cell
battery.
6. Install the
display
assembly.
7. Install the fan.
8. Install the touchpad.
9. Install the
I/O
board.
10. Install the
wireless
card.
11. Install the
solid-state drive/Intel Optane
12. Install the
hard-drive
assembly.
13. Install the
memory
module.
14. Install the battery.
15. Install the
base
cover.
16. Follow the procedure in
64
Removing and installing components
or the
power-button with fingerprint
port.
memory.
After working inside your
computer.
reader.