IMPORTANT!
DO NOT install the appliance on a soft, uneven, or unlevelled floor to avoid twisting the
●
●
appliance and poor door sealing.
If using a Powered driver, use low torque setting to avoid damaging the height adjustment
●
●
system.
Positioning right hinge appliance into the cabinetry
1 Coil the excess water hose and power cord flat behind the appliance.
2 Push the right hinge appliance into the right hand side of the cavity until it makes contact
with the joiner bracket.
3 Adjust the height of the appliance to align inside the cabinetry.
Refer to 'Align appliance inside the cabinetry' in a separate 'Installation guide' supplied with
your appliance.
4 Fasten the cavity bracket to the joiner bracket with two M5x12 socket head cap screws (A).
5 If the appliance is not flush, further loosen the top screws of the cavity attachment bracket if
required and move the bracket in a forward to back motion to suit (B).
6 Recheck appliance flushness (refer to separate 'Installation guide' booklet supplied with your
appliance). Once satisfied with flushness, tighten top screws fix an additional
#8 x 16 mush washer screw (C).
Positioning left hinge appliance into the cabinetry
7 Coil the excess water hose and power cord flat behind the
appliance.
8 Open the door of the right hinge appliance.
9 Push the left hinge appliance into the left hand side of the
cavity until it makes contact with the joiner bracket. (D)
!0 Open the left hinge appliance door to access the brackets (E).
!1 Adjust the height of the appliance to align inside the cabinetry.
Refer to 'Align appliance inside the cabinetry' in a separate
'Installation guide' supplied with your appliance.
Note: For clarity of drawing, top trims are not shown.
●
●
!2 Fasten the cavity bracket to the joiner bracket with two M5x12
socket head cap screws (F).
Note: illustration above shows appliance with RD3684/RD9121 door panel.
10
9
POSITION INTO THE CABINETRY
Ensure that the top, bottom and sidge gaps are not greater than 1/16" (1.5mm) to achieve
●
●
correct alignment.
Final alignment will be achieved once door panels have been installed and the appliance
●
●
is pushed back to sit flush with the cabinetry.
D
A
B
SCALE 2:5
C
SCALE 2:5
E
SCALE 1:10
F