Table of Contents
Advertisement
Preparing the centre trim
1 Remove the M10x65 socket head
cap screws from the base of the
appliances. (A)
2 Attach the bottom joiner bracket
using M10 x 65 Socket head cap
screws. (B)
3 For 80" (2032mm) installation,
cut centre trim using the same
method as instructed for side
trims.
(Refer to 'Cabinet trims installation'
in the Installation guide supplied
with your appliance).
4 Mark out three locations (C) for
the spring clips along the centre trim to match the foam pad
locations on cabinet.
5 Insert right hand spring clip into the centre trim channel. (D)
IMPORTANT!
Ensure the bottom of the right hand spring clip is located on
the right hand side of the channel.
6 Insert the left hand spring clip into the centre trim channel. (E)
Before pushing the left hand spring clip all the way into the
7
trim, squeeze the two spring clips together and push all the way
through. You will hear the spring clips engage into the trim. (F)
Repeat for the remaining two locations on the centre trim.
D
E
!0
ATTACH CENTRE TRIM
B
A
C
F
CLICK!
Attaching the centre trim between appliances
1 Open both appliance doors. Position
the centre trim in front of the gap
between the two appliances. (G)
2 Starting from the upper spring clips,
squeeze the clips to slot between
the two appliances (H).
3 Repeat on the middle and then the lower clips.
4 Using the palm of your hand, push trim all the way down
the length of the appliance.
5 Screw the M8 set screw into the threaded hole of the
bottom joiner bracket to support the centre trim. This
maintains the height position of the trim.
6 Once you are satisfied with the location of the centre
trim, use the M8 nut to lock the set screw into location (I).
Note: illustration above shows appliance with RD3680/RD9120 door panel.
G
H
I
11
Advertisement
Table of Contents
