Product Overview; Controls - Toro SGR-13 Original Instructions Manual

Product Overview

1. Throttle lever
2. Hour meter
3. Cyclone air filter
4. Choke lever
5. Fuel valve
6. Sediment cup
7. Starter

Controls

Become familiar with all the controls
you start the engine and operate the machine.
Safety Bail
The safety bail controls the engine. Hold the safety
bail against the handle when you start the engine and
use the machine. Release the safety bail to shut off
the engine (Figure 3).
Throttle Lever
The throttle lever controls engine speed. With the
lever down, in the D
ISENGAGE
runs at idle. This is also the starting position. When
the engine speed increases, to the E
the centrifugal clutch engages and the cutting wheel
rotates.
Figure 3
8. Cutting wheel
9. Belt cover
10. Lift handle
11. Fuel cap
12. Parking brake
13. Safety bail
14. Handle
(Figure 3) before
position, the engine
NGAGED
1. Throttle—Disengage
position
g205066
Parking Brake
The parking brake holds the left wheel from turning to
secure the machine and for easy movement of the
machine from side to side when grinding a stump
(Figure 5).
1. Parking brake (engaged)
Hour Meter
The hour meter displays the number of hours of
operation that have been logged on the machine.
position,
Choke Lever
Use the choke lever
Before pulling the recoil-start handle, move the choke
lever to the C
running, move the choke lever to the O
Do not use the choke if the engine is already warmed
up or if the air temperature is high.
7
Figure 4
2. Throttle—Engaged
position
Figure 5
2. Parking brake
(disengaged)
(Figure 3) to start a cold engine.
position. Once the engine is
LOSED
g014499
g205069
position.
PEN