Specifications; Attachments/Accessories; Operation; Before You Start - Toro SGR-13 Original Instructions Manual

Recoil-Start Handle
To start the engine, pull the recoil-start handle
6) quickly to turn the engine over. Refer to
Engine (page 10) for the correct starting procedure.
Fuel Valve
The fuel valve (Figure
choke lever. Move the lever for the fuel valve to the
O position before attempting to start the engine.
N
1. Choke
2. Fuel valve

Specifications

Note:
Specifications and design are subject to
change without notice.
Cutting Depth
Length
Width
Height
Weight

Attachments/Accessories

A selection of Toro approved attachments and
accessories is available for use with the machine
to enhance and expand its capabilities. Contact
your Authorized Service Dealer or authorized Toro
distributor or go to www.Toro.com for a list of all
approved attachments and accessories.
To ensure optimum performance and continued safety
certification of the machine, use only genuine Toro
replacement parts and accessories. Replacement
parts and accessories made by other manufacturers
could be dangerous, and such use could void the
product warranty.
Starting the
6) is located underneath the
Figure 6
3. Recoil-start handle
30 cm (12 inches)
193 cm (76 inches)
75 cm (29.5 inches)
107 cm (42 inches)
109 kg (240 lb)

Operation

(Figure
Note:
Determine the left and right sides of the
machine from the normal operating position.
Important:
the fluid levels, and remove debris from the
machine. Ensure that the area is clear of people
and debris. You should also know and have
marked the locations of all utility lines.

Before You Start

•
Dig away the earth and remove any stones near
the tree stump that may interfere with your work.
Check that the ground is free of foreign objects,
such as electrical cables, barbed wire, etc.
•
Cut or trim the stump using a power saw.
•
Review all the safety decals on the machine.
•
Ensure that you are familiar with safety regulations
and shutdown procedures described in this
manual.
•
Ensure that all guards are in place and in good
g015174
condition.
•
Ensure that the blades and cutters are in place
and in good condition.
•
Ensure that the work area, cutter, and stump in
particular are free from metallic objects such as
wire, nails, etc. that could be thrown out and injure
persons in the vicinity and damage the equipment.

Adding Fuel

DANGER
In certain conditions, fuel is extremely
flammable and highly explosive. A fire or
explosion from fuel can burn you and others
and can damage property.
• Fill the fuel tanks outdoors, in an open
area, when the engine is cold. Wipe up any
fuel that spills.
• Never fill the fuel tanks inside an enclosed
trailer.
• Never smoke when handling fuel and stay
away from an open flame or where fuel
fumes may be ignited by a spark.
• Store fuel in an approved container and
keep it out of the reach of children. Never
buy more than a 30-day supply of fuel.
• Do not operate without entire exhaust
system in place and in proper working
condition.
8
Before operating the machine, check