Brake Maintenance; Adjusting The Parking Brake; Belt Maintenance; Adjusting The Drive-Belt Tension - Toro SGR-13 Original Instructions Manual

Brake Maintenance

Adjusting the Parking
Brake
1. Park the machine on a level surface and engage
the parking brake.
2. Shut off the engine and wait for all moving parts
to stop.
3. Loosen the set screw on the side of the
brake-lever knob. Turn the knob clockwise to
tighten the brake; turn the knob counterclockwise
to loosen the brake.
Note:
The left wheel should lock completely
when you engage the brake.
4. Tighten the set screw.

Belt Maintenance

Adjusting the Drive-Belt
Tension
Service Interval: Before each use or daily
Note:
Inspect the drive belt through the slot on top of
the belt cover. Adjust as required.
1. Park the machine on a level surface and engage
the parking brake.
2. Shut off the engine and wait for all moving parts
to stop.
3. Loosen the 2 bolts securing the belt guard to
machine until you can remove the belt guard
(Figure 24).
Note:
The bolts and washers will remain
attached to the belt guard.
1. Belt guard
4. Remove the belt guard
5. Loosen the 4 engine-plate mounting bolts and
the 2 bolts securing the rear of the belt guard to
the engine (Figure 25
18
Figure 24
2. Bolt and washer (2)
(Figure 24).
and Figure 26).
g205161