Page 1
TRIM MOUNTING HOLES (4X) transfer device (electric hinge). See “Wire Routing and Door Prep DRILL 1/2" HOLE Instructions” for 4500 Series Electric Exit Devices, document I-ED00367. 3 5/8" 2 3/16" 4 3/8" REV 3...
Page 2
4500 Series Electric Lever Trim Electrical Supplemental Instructions Grade 1 I-ED00370 2. PREPARE EXIT DEVICE Remove four (4) screws from chassis cover and remove. Separate chassis/push bar from device body by removing two (2) screws located on chassis. After chassis/push bar has been removed from device body, insert cable assembly along the side of push bar. Make sure that connector end is located on the chassis side.
Page 3
4500 Series Electric Lever Trim Electrical Supplemental Instructions Grade 1 I-ED00370 4. SECURE WIRES A. After the exit device and trim is mounted, secure the wires in the back of exit device body with the self-adhesive ty-wrap mount and ty-wrap.