Using The Laser Alignment Unit - Ametek LAND LSP HD Series User Manual

LSP Linescanner Head
HD
4.1 Using the Laser Alignment Unit
The Laser Alignment Unit is a CLASS 2 laser product.
Be aware of all CLASS 2 Laser Safety Warnings whenever the Laser Alignment Unit is in
use.
1) Press the Laser Alignment button. The button is next to the interface connector
on the top of the scanner body.
The scan frequency of the instrument reduces to approximately 1Hz and the
Laser Alignment button flashes to indicate that the laser is active. A red stripe of
laser light is projected through the window of the scanner, indicating the position
and extents of the scan line.
2) Adjust the scanner position as required so that the product almost fills the width
of the scan defined by the laser.
Note
When the Laser Alignment Unit is active, the scanner does not measure the
target temperature.
3) To switch off the laser, press the flashing Laser Alignment button.
When the Laser Alignment unit is switched off, the scanner stabilises for
approximately 60 seconds. The scanner will then begin normal operation and
temperature information is available.
Alternatively, the Laser Alignment facility can be operated remotely from the Landscan
Software.
Page 20
User Guide