Replacing a front bezel
This section covers replacement of the front bezel on the base unit,
expansion unit, and modular 2U SAS expansion unit.
Tool needed
Front bezel key.
Before you begin
Note the following precautions before installing or removing a front bezel.
CAUTION! Attach and remove the front bezel carefully. Otherwise,
you may pinch your fingers between the bezel and the chassis as
it snaps closed.
NOTE: When installing or removing the front bezel, be careful not to
operate the main switch with the hook or the ON/OFF button of the front
bezel. You must unlock the front bezel before you can remove it. The same
key fits both the base unit front bezel and the expansion unit front bezel.
Removing the front bezel
Complete the following steps to remove the front bezel.
1. Insert the key into the keyhole on the front bezel and unlock the lock.
The key cannot be removed from the lock when the lock is in the
unlocked position.
2. Grasp the front bezel on both sides and above the center of the unit. Pull
the front bezel toward you to disengage it from the ball catches. The
bezel will then swing outward at the top.
3. Disengage the two hooks of the front bezel from the slots on the array
chassis by lifting the bezel upward and then pulling it out and away from
the base or expansion unit.
Figure 4-1: Removing the Front Bezel
Replacing parts
Hitachi AMS 2000 Family Storage System Service Guide
4–5