Before You Begin; Unpacking A Power Supply; Verifying That The Power Supply Has Failed - Hitachi AMS 2000 Series Service Manual

Before you begin

Before beginning work, read the following information.
CAUTION! Do not leave a slot open for more than 10 minutes when
replacing a part in a unit that has the power turned on. Loss of
cooling air can cause the unit to overheat and shut down.
When replacing both power supplies, replace them one at a time,
or replace both of them while the power is turned off.
When the power supply and another module fail at the same time,
replace the power supply first. Otherwise, a powering off
(subsystem down) may occur because of an abnormal temperature
rise.
Do not replace any parts while the green Ready LED on the front of
the base unit is blinking at high speed because the firmware is
being downloaded at that time. Wait until the Ready LED is ON
before replacing parts.
Do not replace any parts while the orange Warning LED on the
front of the base unit is blinking at high speed because the
firmware is being installed at that time. Wait 30 seconds after the
Warning LED goes out before replacing parts.

Unpacking a power supply

1. Remove the power supply from its shipping container.
2. Verify that you have the correct model number. See
Replaceable parts
3. Return the power supply to the container until you are ready to install it.

Verifying that the power supply has failed

Verify that the power supply has failed. See
parts.
for the model numbers of the power supplies.
Replacing parts
Hitachi AMS 2000 Family Storage System Service Guide
Chapter 3,
Chapter 2, Identifying failed
4–17