Advertisement
INSTALLATION INSTRUCTIONS
IMPORTANT: READ ALL INSTRUCTIONS THOROUGHLY AND CAREFULLY PRIOR TO INSTALLATION OF LINEAR
SERIES FIXTURES AND RETAIN FOR FUTURE REFERENCE.
HARDWIRED FIXTURES, CONT.:
4.
MAKE ELECTRICAL CONNECTIONS PER ALL APPLICABLE CODES:
•
NORMAL POWER WIRING - BLACK TO BLACK (HOT); WHITE TO WHITE (NEUTRAL) AND GREEN (OR BARE) TO GREEN (GROUND). ENSURE NO BARE WIRES
ARE EXPOSED.
•
DIMMING WIRING – VIOLET TO VIOLET (DIM +); GREY TO GREY (DIM -).
•
EMERGENCY WIRING (WITH SWITCH LEG) - BLACK TO BLACK (HOT); BLACK (THIS MUST BE SUPPLIED BY AND RUN BY A QUALIFIED LOCAL ELECTRICAN TO
FIXTURE WITH EMB DRIVER IF IT IS NOT THE POWER DROP FIXTURE) TO RED (SWITCH); WHITE TO WHITE (NEUTRAL) AND GREEN (OR BARE) TO GREEN
(GROUND). ENSURE NO BARE WIRES ARE EXPOSED.
•
EMERGENCY WIRING (WITHOUT SWITCH LEG) - BLACK TO BLACK (HOT) AND BLACK TO RED (SWITCH) (SAME CONNECTOR); WHITE TO WHITE (NEUTRAL)
AND GREEN (OR BARE) TO GREEN (GROUND). ENSURE NO BARE WIRES ARE EXPOSED.
•
IF WIRING EMB WITH WIRING THROUGH MULTIPLE FIXTURES (CONTINUOUS RUN), MAX AMBIENT ON ALL FIXTURES IS 40°C.
5.
ELECTRICALLY ATTACH LED LIGHT COVER TO FIXTURE HOUSING USING THE QUICK CONNECTOR. NEATLY ARRANGE THE WIRES AND ENSURE ALL THE WIRES
AND CONNECTIONS ARE SEALED PROPERLY INSIDE THE FIXTURE HOUSING. TAKE CARE NOT TO PINCH ANY WIRES.
6.
ATTACH LED LIGHT COVER BY RAISING IT TO THE CHASSIS AND SNAPPING IN PLACE.
7.
INSERT SAFETY SCREW (PROVIDED).
8.
REMOVE PLASTIC FILM FROM LENS.
9.
TURN ON ELECTRICITY AT THE CIRCUIT BREAKER, PANELBOARD, OR FUSE BOX.
FLEXLIGHTINGSOLUTIONS.COM
RED
LIGHTING.TECH@FLEX.COM
RED
888-799-5002 option 3 or 913-851-3000 option 3
LS1 SERIES
11-27-18
Advertisement
