Advertisement
INSTALLATION INSTRUCTIONS
IMPORTANT: READ ALL INSTRUCTIONS THOROUGHLY AND CAREFULLY PRIOR TO INSTALLATION OF LINEAR
SERIES FIXTURES AND RETAIN FOR FUTURE REFERENCE.
MAKING ELECTRICAL CONNECTIONS:
TURN OFF POWER AT PANEL OR BREAKER
STAND-ALONE FIXTURE (FXT):
1.
FIXTURES WITH OPTIONAL FACTORY-INSTALLED CORD WITH WIRE ENDS (WITHOUT PLUG): EXTEND CORD AND WIRE ENDS TO NEAREST ELECTRICAL
JUNCTION BOX (PROVIDED BY CONTRACTOR) AND MAKE FINAL ELECTRICAL CONNECTIONS PER ALL APPLICABLE CODES INSIDE JUNCTION BOX -BLACK TO BLACK
(HOT); WHITE TO WHITE (NEUTRAL) AND GREEN (OR BARE) TO GREEN (GROUND); VOILET TO VIOLET AND GREY TO GREY ON 5-WIRE CORD (IF APPLICABLE).
2.
FIXTURES WITH OPTIONAL FACTORY-INSTALLED CORD AND PLUG: CONNECT CORD AND PLUG TO NEAREST APPROPRIATELY RATED RECEPTACLE (PROVIDED
BY CONTRACTOR).
3.
HARDWIRED FIXTURES:
•
REMOVE LED LIGHT COVER, SEE "REMOVING LED LIGHT COVER (FXT AND LNK)" IN THIS INSTRUCTION.
•
TAKE NOTE WHERE DRIVER IS LOCATED IN LED CHASSIS.
•
CHOOSE A SUITABLE KNOCKOUT LOCATION FROM THOSE PROVIDED IN FIXTURE HOUSING.
•
REMOVE THE KNOCKOUT WITH A SCREWDRIVER.
•
PULL EXISTING AC POWER FROM BUILDING THROUGH KNOCKOUT LOCATION INTO FIXTURE HOUSING. PROVIDE UL APPROVED STRAIN RELIEF (NOT
PROVIDED) AS REQUIRED.
FLEXLIGHTINGSOLUTIONS.COM
KO EXAMPLE LOCATION
DRIVER
LIGHTING.TECH@FLEX.COM
KO EXAMPLE LOCATION
888-799-5002 option 3 or 913-851-3000 option 3
LS1 SERIES
11-27-18
Advertisement
