Advertisement
INSTALLATION INSTRUCTIONS
IMPORTANT: READ ALL INSTRUCTIONS THOROUGHLY AND CAREFULLY PRIOR TO INSTALLATION OF LINEAR
SERIES FIXTURES AND RETAIN FOR FUTURE REFERENCE.
JOINING FIXTURE SECTIONS (FXT OCCUPANCY SENSORS AND CONTROLS):
14. ALL FXT ACCESSORY SENSORS/CONTROLS HAVE ONE END WITH A MECHANINCAL JOINING PIECE (LS-MJP) ATTACHED.
15. REMOVE LED LIGHT COVER FROM EACH SECTION. (SEE "REMOVING LIGHT COVER INSTRUCTION").
16. REMOVE THE PLASTIC ENDCAP FROM THE FIXTURE. REMOVE THE SCREWS AND DEPRESS THE TABS HOLDING IN THE END CAP.
17. SLIDE THE ACCESSORY SENSOR/CONTROL ONTO THE FIXTURE AND SNAP INTO PLACE. IT WILL SELF ALIGN.
AFTER JOINING, FIXTURES HOUSINGS FROM BOTH SECTIONS SHOULD BE FLUSH TOGETHER. REPLACE SCREWS FROM END CAP INTO MECHANICAL JOINING
PIECE (MJP) CONNECTED TO SENSOR, 1 ON EACH SIDE.
18. MAKE FINAL MOUNTING AND WIRING CONNECTIONS.
JOINING FIXTURE SECTIONS (LNK OCCUPANCY SENSORS AND CONTROLS):
19. ALL LNK ACCESSORY SENSORS/CONTROLS HAVE A MECHANINCAL JOINING PIECE (LS-MJP) ATTACHED AT EACH END.
20. REMOVE LED LIGHT COVER FROM EACH SECTION. (SEE "REMOVING LIGHT COVER INSTRUCTION").
21. REMOVE THE PLASTIC ENDCAP FROM THE FIXTURE (REMOVE THE SCREWS AND DEPRESS THE TABS HOLDING IN THE END CAP, IF APPLICABLE).
22. SLIDE THE ACCESSORY SENSOR/CONTROL ONTO THE FIXTURE AND SNAP INTO PLACE. IT WILL SELF ALIGN.
AFTER JOINING, FIXTURES HOUSINGS FROM BOTH SECTIONS SHOULD BE FLUSH TOGETHER.
24. INSTALL SCREWS INTO MECHANICAL JOINING PIECE (MJP) CONNECTED TO SENSOR, 1 ON THE BOTTOM AND 1 ON EACH SIDE.
25. IF THE LNK ACCESSORY SENSOR/CONTROL IS AT THE END OF A RUN OF FIXTURES, REMOVE THE LS-MJP (MECHANICAL JOINING PIECE) FROM THE END OF THE
ACCESSORY AND ATTACH A PLASTIC ENDCAP FROM ONE OF THE EXISTING LNK FIXTURES TO SEAL THE RUN. USE SCREWS PROVIDED TO SECURE END CAP, 1 ON
EACH SIDE.
26. MAKE FINAL MOUNTING AND WIRING CONNECTIONS.
FLEXLIGHTINGSOLUTIONS.COM
LIGHTING.TECH@FLEX.COM
888-799-5002 option 3 or 913-851-3000 option 3
LS1 SERIES
11-27-18
Advertisement
