Advertisement
INSTALLATION INSTRUCTIONS
IMPORTANT: READ ALL INSTRUCTIONS THOROUGHLY AND CAREFULLY PRIOR TO INSTALLATION OF LINEAR
SERIES FIXTURES AND RETAIN FOR FUTURE REFERENCE.
FIXTURE (FXT or LNK) – SUSPENSION MOUNT
1.
INSTRUCTION TO FOLLOW USES FLS HANGERKIT (SOLD SEPARATELY).
LS-CABLEKIT– ITEMS INCLUDED:
•
SINGLE TOGGLE AND GRIPPER, 2 EACH.
INSTALLING SUSPENSION MOUNT (FXT and LNK):
1.
SEE GENERAL INSTRUCTIONS AT THE FRONT OF THIS INSTRUCTION.
2.
4' SECTION: PRESS GRIPPER AGAINST CABLE SO GRIPPER AND CABLE ARE PARALLEL.
3.
INSERT SINGLE GRIPPER/CABLE INTO FIXTURE THROUGH KEYHOLE AT END OF FIXTURE.
4.
PUSH GRIPPER/CABLE THROUGH HOLE UNTIL GRIPPER CANNOT BE HANDLED (IS NOT SEEN).
5.
PULL CABLE TIGHT. GRIPPER LAYS INSIDE FIXTURE HOUSING AND WILL NOT PULL OUT.
6.
SECURE HANGER CABLE TO STRUCTURE.
•
4FT SECTION: MINIMUM 2 HANGER POINTS
•
CONTINUOUS RUN: MINIMUM 2 HANGER POINTS PER 4' SECTION IS RECCOMENDED.
•
USE LS-YCABLE AT ALL FIXTURE JOINT LOCATIONS, 1 "Y" TO EACH FIXTURE IN THE RUN FOR SUPPORT.
•
USE LS-CABLEKIT SINGLE TOGGLES FOR THE ENDS.
7.
PASS LOOP SIDE OF CABLE OVER, AROUND AND UNDER STRUCTURE.
8.
PASS STRAIGHT END OF CABLE THROUGH LOOP AND PULL TIGHT.
9.
RAISE FIXTURE WITH TOGGLE AND GRIPPER TO LOOP CABLE SECURED TO STRUCTURE.
10. PASS STRAIGHT END OF LOOP CABLE THROUGH TOGGLE. PLUNGER ON TOP OF TOGGLE CATCHES AND HOLDS CABLE SECURELY.
11. LEVEL FIXTURE PLUMB WITH BUILDLING LINES. (TO LET OUT CABLE, PUSH PLUNGER DOWN).
12. MAKE FINAL WIRING CONNECTIONS. REFER TO "MAKING ELECTRICAL CONNECTIONS".
FLEXLIGHTINGSOLUTIONS.COM
SECTION VIEW OF
FIXTURE
3 POINT MOUNT
4 POINT MOUNT
LIGHTING.TECH@FLEX.COM
888-799-5002 option 3 or 913-851-3000 option 3
LS1 SERIES
GRIPPER
SINGLE
TOGGLE
STRUCTURE
11-27-18
Advertisement
