Advertisement
INSTALLATION INSTRUCTIONS
IMPORTANT: READ ALL INSTRUCTIONS THOROUGHLY AND CAREFULLY PRIOR TO INSTALLATION OF LINEAR
SERIES FIXTURES AND RETAIN FOR FUTURE REFERENCE.
JOINING FIXTURE SECTIONS (FXT AND LNK):
1.
ALL SECTIONS ARE 4'.
2.
EACH 4' SECTION HAS ITS OWN DRIVER.
3.
LNK (LINKING) FIXTURES ARE PURCHASED TO BE JOINED IN A CONTINUOUS RUN. MAX 15 LINKED FIXTURES PER POWER DROP.
4.
FXT (NON-LINKING FIXTURES) MAY BE LINKED WITH THE ADDITIONAL ACCESSORY "LS-MJP" (MECHANICAL JOINING PIECE), SOLD SEPARATELY. IF THIS OPTION
IS CHOSEN, INSTALLER MAY WIRE PER APPLICABLE LOCAL CODE.
5.
MOUNTING MAY BE DONE ONE FIXTURE AT A TIME, AND THEN JOINED TOGETHER.
6.
DO NOT SUPPORT CONTINUOUS ROW OF FIXTURES FROM JUST ONE END. SUPPORT THE ENTIRE RUN WHILE HANDLING OR MOUNTING.
7.
ORIENT EACH FIXTURE SECTION IN THE SAME DIRECTION. PLACE FIXTURES END TO END AS THEY WOULD BE INSTALLED.
8.
REMOVE LIGHT COVER FROM EACH SECTION. (SEE "REMOVING LIGHT COVER INSTRUCTION")
9.
LNK FIXTURES COME WITH ONE END OF THE FIXTURE WITH A PLASTIC JOINING PIECE (MALE TO MALE CONNECTOR) ON ONE SIDE OF THE FIXTURE. THE OTHER
SIDE HAS A PLASTIC ENDCAP.
A
JOINING FIXTURE SECTIONS – cont. (FXT AND LNK):
10. LOCATE THE END FIXTURE. THIS WILL BE THE START OF THE RUN.
11. REMOVE THE PLASTIC ENDCAP FROM THE SECOND FIXTURE IN THE SERIES. REMOVE THE SCREWS AND DEPRESS THE TABS HOLDING IN THE END CAP.
12. SLIDE THE SECOND FIXTURE ONTO THE LS-MJP (MECHANICAL JOINING PIECE) OF THE FIRST FIXTURE AND SNAP INTO PLACE. IT WILL SELF ALIGN.
AFTER JOINING, FIXTURES HOUSINGS FROM BOTH SECTIONS SHOULD BE FLUSH TOGETHER. USE SCREWS PROVIDED TO SECURE MECHANICAL JOINING PIECE
(MJP), 1 ON THE BOTTOM AND 1 ON EACH SIDE.
13. CONTINUE UNTIL DESIRED INSTALLATION IS COMPLETE. MAX 15 LINKED FIXTURES PER POWER DROP. LS-BRACE (SOLD SEPARATELY) PROVIDES ADDITIONAL
SUPPORT FOR SECTIONS WHEN ONLY TWO CABLE MOUNTS ARE AVAILABLE.
SECTION "8B"
SECTION "8A"
FLEXLIGHTINGSOLUTIONS.COM
B
SECTION "8B"
SECTION "8A"
SECTION "8B"
LS-MJP
LIGHTING.TECH@FLEX.COM
C
SECTION "8B"
SECTION "8A"
SECTION "8B"
ENDCAP
888-799-5002 option 3 or 913-851-3000 option 3
LS1 SERIES
SECTION "8B"
11-27-18
Advertisement
