Electrical Installation - Valor Ultimate Turbochim BR517S Installer's Manual

P A R T 5 : E L E C T R I C A L I N S T A L L A T I O N
Figure 9 Electrical control
unit fixings
Figure 10 Control cover fixing
5.1 Install a power supply at a switched fuse having a minimum separation of
3mm at all poles. The spur should be readily accessible to the user, easily
identifiable and preferably sited adjacent to the appliance. It should only connect
this appliance.
5.2 To simplify installation of the cable supplied, it may be most convenient
to disconnect it from the appliance as described below, install it to the wall and
then reconnect to the appliance:
To disconnect the cable:
1) Detach the burner (See section 4.5).
2) Detach the control unit from the convection box left side flange by
removing two screws (see figure 9). Carefully pull the unit slightly
forward.
3) Detach the control unit cover by removing one screw (See figure 10).
4) Remove the cable by releasing the cable clamp and detaching the
leads from the terminal block and earth contact tag.
5.3 When installing the cable, leave a minimum of 200mm of the
cable slack at the cable clamp end to allow installation of the appliance
after reconnection to the control box and to allow future removal of the
control box for servicing.
5.4 If the spur is at the right side of the appliance, run the cable
under the hearth. The cable must not run directly under or behind the
appliance.
!
:
WARNING Do not switch on the power supply until after the
fan cable has been correctly connected to the junction box - See
part 8.
12