How To Install The Detachable Airbag System; Storage, Cleaning And Service Life - Scott ALPRIDE E1 User Manual

Table of Contents

Advertisement

Available languages

Available languages

HOW TO INSTALL THE DETACHABLE AIRBAG SYSTEM

1 Open the air bag compartment zipper until about 3 cm
to the end.
3
2
1
4
3 Close the compressor compartment cover and attach
the hooks.
STORAGE, CLEANING & SERVICE LIFE
STORAGE
Store your SCOTT ALPRIDE E1 AIRBAG SYSTEM in a cool, dry environment. For safety reasons, keep the backpack out of
the reach of children. SCOTT Sports SA shall not be liable for any damages and losses due to improper storage.
CLEANING
Use only water (no cleaning products  ! ) to clean the backpack. Ensure that the entire product is dry before using it again to
avoid the risk of icing. In case of a dirty inflator, the inflator system must be cleaned properly with a damp soft microfiber
towel. SCOTT Sports SA shall not be liable for any damages and losses due to improper cleaning.
DISPOSAL
Dispose of the product in domestic waste. Do not mechanically disrupt or incinerate the product. This may lead to
potential hazards.
Electrical appliance  :
Never dispose of electrical appliance in your household waste.
Return electrical appliance using the recycling facilities provided.
Contact your local refuse disposal authority for more details.
AA  /   L R6 1.5 V Batteries  :
Never dispose of batteries in your household waste.
They may contain toxic heavy metals and are subject to hazardous waste regulations.
The chemical symbols of the heavy metals are: Cd = cadmium, Hg = mercury, Pb = lead.
Only dispose of batteries when they are fully discharged.
Before disposing of the appliance it is essential to first remove the batteries.
Return batteries using the recycling facilities provided.
Contact your local refuse disposal authority for more details.
SERVICE LIFE
The product has a limited life time and should be replaced in case of signs of mechanical wear. It is recommended to
regularly control your gear and to replace it at least every five years after first use. The functioning could be reduced due
to mechanical wear or improper use. Dispose of the product if you notice any damage. The SCOTT ALPRIDE E1 AIRBAG
SYSTEM is designed to withstand 50 inflations.
ENGLISH -12
SWBAG_19_PACK-MNL_Alpride-E1_A5-148x210mm_v2.indd 12
3cm
2 Put the trigger handle through the velcro slot and insert
it in the shoulder strap pocket. Pass the airbag through
the two holes to the air bag compartment.
4 Fold the air bag (see section       V III.)
Attach the trigger handle (see section       I X.)
29.05.18 16:59

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents