Siemens SIMATIC RI45 PII Series Product Information Bulletin page 20

Unpacking and Installing the RI45 PII
4 CD Tray
This tray prevents dust from getting inside the CD-ROM reader and should re-
main closed. If your RI is not switched on you can manually push the tray and
close the door of your CD-ROM drive.
5 Emergency
Use a paper clip or any other device to open the CD-ROM tray if the electrical
Eject Hole
eject is disabled by software or if power failure occurs (See "Emergency Eject"
for details).
6 Open/
This button is pressed to open or close the CD tray when the power of your RI
Close Button
is on.
Emergency Eject
The procedure described below can be used to remove a disk from the CD-ROM
reader if the Open/Close button is disabled by software or a power failure occurs.
In this case the CD tray cannot be opened automatically.
1. Turn off the power to the CD-ROM reader (switch off your device if neces-
2. Insert a steel rod or a stiff paper clip (with a maximum diameter of 1.3 mm
Operating your By pushing the Open/Close button the CD tray is smoothly opened. Place the
CD-ROM drive
CD with the labeled side upward into the tray. The tray is closed
automatically after a short push or after having pushed the Open/Close
button.
Caution
!
Risk of data loss and damage to the drive!
CD-ROM drives are sensitive to vibrations and shock. Any vibrations occuring
during operation can lead to damage to the drive or CD.
2-10
sary).
and a minimum length of 55 mm) into the emergency eject hole at the front
of the drive and push lightly. The CD tray is ejected by about 10 mm. Pull
it all the way open by hand and lift the disk out carefully.
at least
55 mm in length
Product Information Bulletin RI45 PII
C79000-Z7076-C814-02