Parker SciLog LabTec Installation, Operating, & Maintenance Instructions page 14

4. Press "Exec" key, select "Exec 1", the LabTec™ will show the following display:
While the message is being displayed, the LabTec™ checks the scale communication and the
following display is shown if all is well:
Press the "RUN" key or alternatively, press the foot switch:
Place the sample bag or container onto the scale and underneath the dispensing tip. Press "RUN"
key or the foot switch. The LabTec™ will show the following display:
This display is followed by:
5. Place the sample into the bag or container, only an approximate sample weight is needed.
The weight ratio will be applied to the actual sample weight as determined by the scale.
Press "RUN" key or the foot switch, the LabTec™ will start dispensing and display the progress:
14
SCALE INITIALIZATION
Please Wait
WGT RATIO SET: 9.00
Press RUN When Ready
Press RUN When
VESSEL IS ON SCALE
REMOVING TARE WEIGHT
Please Wait
Press RUN When
SAMPLE IS IN VESSEL
RUN