Table of Contents
Advertisement
With the setting Enable multilink H.323 = On and a valid Multicast
group IP address, the device operates in multicast mode (duplica-
tion of the data streams in the network).
Enable multicast streaming:
During multicast streaming, the VideoJet 100 sends a permanent
data stream to the specified group IP address. No specific receiver
is defined. Each receiver is thus able to receive the data. The trans-
mission rate is determined purely by the transmitter and has to be
set there. For this, a valid multicast group IP address must be set.
Multicast group IP address:
A precondition for the multicast mode in a multicast-compatible net-
work is the establishment of a special IP address (class D address).
The network must support the establishment of a group IP address
and the Internet Group Management Protocol (IGMP). The address
range is from 224.0.1.0 to 238.255.255.255.
Multicast video port:
The video port does not have to be configured manually and is
shown here only for information for special applications.
Multicast audio port:
The audio port does not have to be configured manually and is
shown here only for information for special applications.
Multicast packet TTL:
By setting the parameter you determine the life span of the data
packets in the network.
Version
The version numbers of the hardware and software are provided
information
only as information and cannot be changed. Keep these numbers
at hand in case you need technical assistance.
Hardware version:
The hardware version number of the VideoJet 100 is displayed.
Software version:
The software version number of the VideoJet 100 is displayed.
VideoJet 100
Configuration with web browser
71
Advertisement
Table of Contents
