VCS VideoJet 100 Manual page 63

The high picture resolution is only supported if you have chosen the
H.263 as the Video standard: setting on the Video settings con-
figuration page.
Frame rate:
Here choose the desired frame rate.
Duration (only for Ring mode):
Here choose the duration of the pre-alarm history recording period.
Recordings made during this period will not be over-written once an
alarm has been triggered.
Note
You can limit recording on the video ring buffer to alarm events by
setting this parameter to 0 and choosing the corresponding entries
in the Alarm trigger section.
Alarm trigger:
Here you select an event which is to trigger the alarm. You have the
following options:
!
!
!
!
Resolution on alarm:
Here select the video resolution for recording after an alarm has
been triggered. You can choose from High, Standard and Low res-
olution.
For each resolution the corresponding picture size is:
VideoJet 100
Input 1 ... Input 4: Trigger by external alarm generating devices.
Video alarm: Trigger when a video signal is interrupted.
Motion alarm: Trigger through motion detection.
---: This option is to be chosen if no changes in the video settings
are desired in case of alarm.
Low 176 × 144 pixels
Standard 352 × 288 pixels
High 704 × 288 pixels
Configuration with web browser
63