Table of Contents
Advertisement
4.27
Move the machine at least 3m away from the refuelling point before starting
engine.
4.28
ALWAYS check the fuel/oil mixture level of the engine before use.
4.29
Inspect that all nuts and bolts are tight and well connected to ensure the
safety and reliability of this machine prior to any operation.
4.30
After allowing the engine to warm up before operation.
4.31
To accelerate the engine to working speed, squeeze the throttle lever (1) towards the
main handle.
4.32
DO NOT force the auger drill bit into the ground, instead allow the machine to do all
the work.
4.33
If the machine jams you MUST release the throttle and move the auger drill bit
before re-commencing work.
4.34
To remove blockages DO NOT under any circumstances use your hands.
4.35
Stop and disable the machine by removing the HT lead plug cap (1).
(1) HT Lead Plug Cap
4.36
Clear the auger drill bit of materials which have become stuck to the auger bit.
(1)
(1)
14
Advertisement
Table of Contents
