Frequency Reverse; Talk Around; Battery Capacity Enquiry - AnyTone AT-518Plus Instruction Manual

ADVANCED OPERATIONS

Frequency Reverse

Under standby conditions, press the programmed key of Frequency Reverse [PF1]/[PF2], transceiver
emits "DU" beep and then comes into frequency reverse state. After that, the current channel RX
frequency will be switch to TX frequency, and the CTCSS or DCS signal which has been setup will
be also switched. Press this key again, the transceiver exits reverse function with "Du Du".

Talk Around

Under the standby conditions, press the programmed key of Talk Around [PF1]/[PF2], transceiver
emits "DU" and then the current channel comes into Talk Around state. Under these conditions,
transceiver will transmit by receiving frequency. Also, the setting code (CTCSS / DCS) will
interchange encoding signal as decoding signal.
Press this key again, transceiver emits "DU DU" and exits the Talk Around state.
NOTE: Under the talk around state , the transceiver can not communicate with other transceivers
through repeaters.

Battery Capacity Enquiry

Under the standby conditions, press the programmed key of "Battery Capacity Enquiry" [PF1]/[PF2],
transceiver announce current battery capacity. There are 10 grades in total. Grade 10th means full
battery capacity.
When the battery state is grade 1th (6.1V), the LED lights red. The transceiver will voice prompt
users to charge timely and also enter automatically the state of no transmission.
15
Professional
FM Transceiver