6-5-2) Output Device Position Adjustment; 6-6) Output Device Clamp Setting - SunStar SJS/A-BA2 User Manual

Direct-drive, automatic 2-needle belt loop sewing machine

Hide thumbs Also See for SJS/A-BA2:

Table of Contents

6.5.2) Output Device Position Adjustment

Loosen the output device stopper screw and adjust the

stopper position in line with the belt loop.

6.6) Output device clamp setting

1) Press the arrow on the Operational Panel and press No. 6 Origin to set the origin.

2) Set the origin following same as the method for bartack.

3) Set the feed plate and the presser foot.

4) Set the output clamps. The clamps of the output device are critical components for supplying belts. If the setting is

improper, the belt loop is escaped or twisted.

When the edge of the belt holding plate (upper) and the

edge of the filler are at the same level, fasten the grape

guide fixing screw. (When the clamps hold the fabric)

Adjust the belt guide on the left and right side. At this

time, the bulged part at the end of the filler should be

placed at the center of the belt and to do this adjust the

tightening screw.

Belt holding plate

(upper)

Filler

Tightening

screw

Belt guide

Table of Contents