Mountings And Connections; Packing; Fitting The Burner To The Boiler - Unigas RG515 Manual Of Installation - Use - Maintenance

MOUNTINGS AND CONNECTIONS

Packing

The burners are dispatched in wooden packages whose dimensions are:
series 9x: 1720 mm x 1270 mm x 1020 mm (L x P x H)
series 5xx: 1800 mm x 1500 mm x 1300 mm (L x P x H)
Packing cases of this kind are affected by humidity and are not suitable for stacking. The following are pla-
ced in each packing case.

burner;

light oil flexible hoses;

light oil filter;

gasket to be inserted between the burner and the boiler;

envelope containing this manual.
To get rid of the burner's packing, follow the procedures laid down by current laws on disposal of materials.

Fitting the burner to the boiler

To install the burner into the boiler, proceed as follows:
1 make a hole on the closing door of the combustion chamber as described on paragraph "Overall dimensions")
2 place the burner to the boiler: lift it up and handle it according to the procedure described on paragraph "Handling the burner";
3 place the 4 stud bolts (5), according to the burner's drilling plate described on paragraph "Overall dimensions";
4 fasten the 4 stud bolts;
5 place the ceramic fibre plait on the burner flange;
6 install the burner into the boiler;
7 fix the burner to the stud bolts, by means of the fixing nuts, according to the next picture.
8 After fitting the burner to the boiler, ensure that the gap between the blast tube and the refractory lining is sealed with appropriate
insulating material (ceramic fibre cord or refractory cement).
The burner is designed to work positioned according to the picture below. For different installations, please contact the Technical
Department.
Keys
1 Burner
2 Fixing nut
3 Washer
4 Ceramic fibre plait
5 Stud bolt
7 Blast tube
SIDE UP
SIDE
DOWN
11
H
L
P