Troubleshooting Tips - ZNYX ZX240 Series User Manual

Troubleshooting Tips

For all operating systems, if you are having difficulty, we recommend you try the following:
•
Be sure the board is securely seated in the slot.
•
Refer to the operating system-specific documentation to evaluate any error messages
or logs after the driver is loaded.
•
Note the LED light activity (see section below).
LED Reference Key
The table below references the LED activity of the ZX240 Series PMC and PIM cards.
Each port on the ZX244 PMC card is linked to an LED so you know immediately if the port has an
established link (green) and is transmitting or receiving activity (amber).
The rear PIM card includes an LED for each port that can be one of three colors: green, white or
amber (see table below).
NOTE In most cases, the driver must be properly loaded and configured to bring up the link.
ZX244 PMC
ZX244 ZX244
LED
F or L R or T
Power
Operate
(Operational)
Fault Int
(Internal Fault)
Fault Ext
(External Fault)
Lnk Act (1-4)
(Link/Activity)
ZX244 PIM
Tri-color LEDs
1, 2, 3, or 4
ZX240 Series User Guide
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Color
Green ON indicates the power source is active.
Green ON indicates the driver is loaded and the
board has passed internal tests.
Red ON indicates a failure of the internal tests.
Red ON indicates a failure external to the
adapter—inability to establish a link on a
configured port, or another connectivity
problem external to the adapter.
Green ON indicates the receiver side is properly
connected and active.
ON indicates the link is active and either
Amber
receiving or transmitting.
Green Below a numbered LED indicates the
corresponding port has an established
link.
Indicates the corresponding port is active
Amber
and either receiving or transmitting.
Indicates the corresponding port is not
White
linked or active.
Function
Page 9