Page 1
Artisan Technology Group is your source for quality new and certified-used/pre-owned equipment SERVICE CENTER REPAIRS WE BUY USED EQUIPMENT • FAST SHIPPING AND DELIVERY Experienced engineers and technicians on staff Sell your excess, underutilized, and idle used equipment at our full-service, in-house repair center We also offer credit for buy-backs and trade-ins •...
Page 2
ZX244F PMC ZX244F ZX244R PIM ZX240 S ERIES UIDE Fast Ethernet Adapter with Rear I/O for PCI Mezzanine Connector (PMC) Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com...
Page 4
WELCOME! Thank you for choosing the ZX240 Series embedded PCI Mezzanine Card (PMC) Fast Ethernet Adapter with rear I/O. Your adapter is designed to provide a lifetime of superior service in your system with PMC slots. The ZX240 PMC Series adapter is a two piece unit equipped with the following features: •...
If it becomes necessary to have one or more ports of the ZX244L attached to a cable, then you also need to use the ZX244T. Contact your ZNYX Networks Sales Representative for additional design constraints regarding the ZX244L for both internal and external Ethernet ports.
2. Insert the ZNYX Networks PMC adapter card into the PMC slot. NOTE Insert the bezel of the ZNYX Networks adapter into the PMC cutout on the front panel of the motherboard or carrier card. Do not allow the gasket in the groove of the bracket to become damaged.
3. Guide the adapter down over the alignment pin. Fully seat the adapter into the mating connectors on the MCPN750. 4. Secure four (4) retention screws and two (2) standoffs, included with card, through the ZNYX Networks adapter standoffs and tighten. 5. Reinstall the motherboard or carrier card in the system. ZX244R or T...
All ZNYX adapters support Plug-and-Play functionality. If you have a Plug-and-Play system, your card will configure itself automatically. If your operating system does not discover the board, you can verify that your adapter is property configured by running the ZNYX DOS-based diagnostics program.
Page 9
Testing Each Adapter Channel Test the connection for each adapter channel by running the ZNYX program, DIAG244.exe (download from the ZNYX web site) for each bus and device number. 1. Enter the following command, in DOS, for each device number: >DIAG244 (bus number) (device number)
Note the LED light activity (see section below). LED Reference Key The table below references the LED activity of the ZX240 Series PMC and PIM cards. Each port on the ZX244 PMC card is linked to an LED so you know immediately if the port has an established link (green) and is transmitting or receiving activity (amber).
Cet appareil numeriqué de la classe A est conforme à la norme NMB-003 du Canada. CE Conformity (Pending): The ZX240 Series is in compliance to CE testing according to the following standards with respect to the stated level and given criteria:...
ZNYX Networks or its authorized dealer. In order for this warranty to be valid, this hardware product must remain in its original system and be registered with ZNYX Networks within one year of purchase.
Page 13
Artisan Technology Group is your source for quality new and certified-used/pre-owned equipment SERVICE CENTER REPAIRS WE BUY USED EQUIPMENT • FAST SHIPPING AND DELIVERY Experienced engineers and technicians on staff Sell your excess, underutilized, and idle used equipment at our full-service, in-house repair center We also offer credit for buy-backs and trade-ins •...