Related Manuals for ZNYX NetBlaster ZX414U3
Summary of Contents for ZNYX NetBlaster ZX414U3
- Page 1 (217) 352-9330 | Click HERE Find the ZNYX Networks ZX414U3 at our website:...
- Page 2 User’s Guide NetBlaster ZX410 Series Fast Ethernet Adapters for CompactPCI Systems...
- Page 3 ZNYX may have patents, pending patent applications, trademarks, copyrights or other intellectual property rights covered in the subject matter of this document. By furnishing this document, ZNYX does not license nor waive its license to those intellectual property rights except as expressly provided in a written license agreement from ZNYX.
-
Page 4: What's In The Package
1. Install the hardware. 2. Install the driver. To get the most recent operating system specific driver, go to the ZNYX web site at www.znyx.com. If the required driver cannot be located on the ZNYX web site, contact ZNYX Technical Support at (800) 724-0911 or support@znyx.com. -
Page 5: Hardware Installation
4. Remove the slot cover from the front panel slot filler bracket. 5. Insert the ZNYX adapter into the slot. Make certain that you push the adapter straight into the slot; the bracket and the slot must be properly aligned and the adapter fully “seated”. -
Page 6: Connecting To The Network
Ethernet cables should be attached. If this is not the case, return to the “Hardware Installation” procedure in the previous section. Download operating system specific driver from the ZNYX web site (www.znyx.com). Included with the driver is a release note with installation and configuration instructions. Please follow these directions to configure the driver. - Page 7 >DIAG41x LIST 2. You will see a list below. (This example is for the ZX414.) DIAG414 Version 1.38 for ZNYX NetBlaster ZX414 4/100 Mbps adapter (c) Copyright 1994-1998 ZNYX Corporation - All Rights Reserved. PCI BIOS Information: Version=2.10, Config Mechanism=1, Last Bus=2...
-
Page 8: Basic Troubleshooting
2. Check the green link LED’s. The LED will be on when attached to an active interface (hub, switch, router, or any other system). See figure below: 3. Refer to operating system specific documentation to evaluate any error messages or logs when the driver is loaded. ZNYX NetBlaster ZX410 Series User’s Guide ZNYX Page 7 ZNYX... -
Page 9: Technical Support
ZNYX or its authorized dealer. In order for this warranty to be valid, this hardware product must remain in its original personal computer and be registered with ZNYX within one year of purchase. - Page 10 ZX414 LASTER Modification to this product not authorized by ZNYX Corporation could void the FCC approval and negate your authority to operate the product. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules.
- Page 11 ZNYX or its authorized dealer. In order for this warranty to be valid, this hardware product must remain in its original personal computer and be registered with ZNYX within one year of purchase.
-
Page 12: Warranty Registration Card
Solaris VxWorks pSOS Windows NT LynxOS Other (specify) SCO Unix Please indicate your processor: Intel PowerPC SPARC Alpha Mips StrongARM Other Would you like additional information on ZNYX products? ZNYX NetBlaster ZX410 Series User’s Guide ZNYX Page 11 ZNYX ZNYX...