Hardware Installation - ZNYX ZX240 Series User Manual

HARDWARE INSTALLATION

You can easily install a ZNYX Networks adapter into an open slot on a Motorola MCPN750
computer or CPV8540 PMC carrier card. Refer to your system documentation if necessary.
Installing the ZX240 Series Adapter
This procedure includes all steps required for installing both the front and rear pieces (PMC and
PIM cards) of the ZX240 adapter.
Preparing for the Install
•
Power off your system.
•
Discharge any static electricity from your body by touching the metal chassis, or by
using an anti-static wrist strap. If you do not have a ground strap, maintain physical
contact with the case to maintain the same electrical potential with the system.
•
Remove the motherboard or carrier card, containing at least one available single-
wide PMC slot from the system chassis.
Installing the PMC Card
1. Remove the cover from an empty single-wide PMC slot on the motherboard or carrier card.
2. Insert the ZNYX Networks PMC adapter card into the PMC slot.
NOTE Insert the bezel of the ZNYX Networks adapter into the PMC cutout on the front panel of
the motherboard or carrier card. Do not allow the gasket in the groove of the bracket to become
damaged. Do not operate without the gasket properly seated.
ZX240 Series User Guide
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
ZX244F or L
PMC Card
Page 5