Table of Contents
Advertisement
2.0 INSTALLATION
Stove rotating
2.6 - Stove Rotation Cont.
The wall distances for rotating installation are present-
The wall distances for rotating installation are presented below.
ed below.
100 cm
45°
Fig.5 Stove rotating, installed straight in corner
2.7 - Assembly sequence
• The Ø 150 stovepipe connection can be installed at the top or rear. The stove is supplied ready for
connection from above. If you wish to connect it at the rear, the following steps must be carried out to
make the necessary modifications:
- Break out the cover in the back panel.
- Replace the connector sleeve and the sealing cover.
• Install the pipe lining (provided on site) in the chimney. The connection height can be individually specified
for a top stovepipe connection, however should not exceed 1.5 m from the connector sleeve. For the
40 cm
rear stovepipe connection heights please refer the "Technical Data" chapter. No combustible material is
permitted within a radius of 20 cm around the stove pipe.
• Connect the stovepipe at both connection points with stove putty so that the stove pipe is permanently
sealed.
45°
• Push the stove onto its planned position and orient it so that the stovepipe fits into the pipe lining.
Fig.6 Stove rotating, installed diagonally in corner
The stovepipe connections must be tight. The stovepipe must not protrude into the chimney. Bear in mind
that on partition walls in accordance with test specification EN 13240 the temperature of 85°C can be
reached, and with light wallpaper or similar combustible construction materials this can result in colour
changes.
Assembly sequence
● The Ø 150 stovepipe connection can be installed at
the top or rear. The stove is supplied ready for con-
Fig.5 Stove rotating, installed straight in corner
nection from above. If you wish to connect it at the
rear, the following steps must be carried out to make
the necessary modifications:
- Break out the cover in the back panel.
- Replace the connector sleeve and the sealing
cover.
● Install the pipe lining (provided on site) in the chim-
ney. The connection height can be individually spec-
ified for a top stovepipe connection, however should
not exceed 1.5 m from the connector sleeve. For the
100 cm
rear stovepipe connection heights please refer the
"Technical Data" chapter. No combustible material is
permitted within a radius of 20 cm around the stove
pipe.
45°
● Connect the stovepipe at both connection points
with stove putty so that the stove pipe is permanent-
ly sealed.
● Push the stove onto its planned position and orient it
so that the stovepipe fits into the pipe lining.
The stovepipe connections must be tight. The
Fig.6 Stove rotating, installed diagonally in corner
stovepipe must not protrude into the chimney.
Bear in mind that on partition walls in accordance
with test specification EN 13240 the temperature
of 85°C can be reached, and with light wallpaper
or similar combustible construction materials this
can result in colour changes.
45°
PAGE 12
100 cm
45°
40 cm
45°
ified
not e
100 cm
rear
"Tec
perm
pipe
45°
● Conn
with
ly se
● Push
so th
The st
stovep
Bear in
with te
of 85°C
or sim
can res
45°
Advertisement
Table of Contents
